DESIGN OF LOW LEAKAGE CURRENT AVERAGE POWER CMOS CURRENT COMPARATOR USING SVL TECHNIQUE WITH PSEUDO NMOS AND TRANSMISSION GATE LOGICS

Publications

Share / Export Citation / Email / Print / Text size:

International Journal on Smart Sensing and Intelligent Systems

Professor Subhas Chandra Mukhopadhyay

Exeley Inc. (New York)

Subject: Computational Science & Engineering , Engineering, Electrical & Electronic

GET ALERTS

eISSN: 1178-5608

DESCRIPTION

7
Reader(s)
25
Visit(s)
0
Comment(s)
0
Share(s)

VOLUME 10 , ISSUE 5 (December 2017) > List of articles

Special Issue

DESIGN OF LOW LEAKAGE CURRENT AVERAGE POWER CMOS CURRENT COMPARATOR USING SVL TECHNIQUE WITH PSEUDO NMOS AND TRANSMISSION GATE LOGICS

T.R. Dinesh Kumar / K.Mohana Sundaram / M.Anto Bennet / M. Pooja / A.P. Kokila

Keywords : current comparator, SVL circuit, pseudo nmos, transmission gate, low power consumption, standby mode.

Citation Information : International Journal on Smart Sensing and Intelligent Systems. Volume 10, Issue 5, Pages 344-357, DOI: https://doi.org/10.21307/ijssis-2017-256

License : (CC BY-NC-ND 4.0)

Received Date : 27-May-2017 / Accepted: 15-June-2017 / Published Online: 01-September-2017

ARTICLE

ABSTRACT

Comparatorare most widely used second electronic components after operational amplifier. For ADC circuit we have to use the high speed and low power consumption based comparator. SVL circuit is used tom reduce the offset voltage which requires high voltage gain. A SVL circuit can supply maximum DC voltage to an active load circuit on request or can decrease the DC voltage supplied to a load circuit in the standby mode was developed. SVL circuit is used with comparator which reduce the power consumption from 258.6μw to 156.7μw. Pseudo nmos logic and transmission gate logic is used with the SVL based current comparator which further reduce the power consumption in the standby mode. This technique based comparator is fabricated on the tanner tool of 45nm technology.SVL technique is mostly recommended for CMOS logic.

Content not available PDF Share

FIGURES & TABLES

REFERENCES

[1] Aizat Azmi, Ahmad Amsyar Azman, Sallehuddin Ibrahim, and Mohd Amri Md Yunus, “Techniques In Advancing The Capabilities Of Various Nitrate Detection Methods: A Review”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 2, June 2017, pp. 223-261.

[2] Tsugunosuke Sakai, Haruya Tamaki, Yosuke Ota, Ryohei Egusa, Shigenori Inagaki, Fusako Kusunoki, Masanori Sugimoto, Hiroshi Mizoguchi, “Eda-Based Estimation Of Visual Attention By Observation Of Eye Blink Frequency”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 2, June 2017, pp. 296-307.

[3] Ismail Ben Abdallah, Yassine Bouteraa, and Chokri Rekik , “Design And Development Of 3d Printed Myoelctric Robotic Exoskeleton For Hand Rehabilitation”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 2, June 2017, pp. 341-366.

[4] S. H. Teay, C. Batunlu and A. Albarbar, “Smart Sensing System For Enhanceing The Reliability Of Power Electronic Devices Used In Wind Turbines”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 2, June 2017, pp. 407- 424

[5] SCihan Gercek, Djilali Kourtiche, Mustapha Nadi, Isabelle Magne, Pierre Schmitt, Martine Souques and Patrice Roth, “An In Vitro Cost-Effective Test Bench For Active Cardiac Implants, Reproducing Human Exposure To Electric Fields 50/60 Hz”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 1, March 2017, pp. 1- 17

[6] P. Visconti, P. Primiceri, R. de Fazio and A. Lay Ekuakille, “A Solar-Powered White Led-Based Uv-Vis Spectrophotometric System Managed By Pc For Air Pollution Detection In Faraway And Unfriendly Locations”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 1, March 2017, pp. 18- 49

[7] Samarendra Nath Sur, Rabindranath Bera and Bansibadan Maji, “Feedback Equalizer For Vehicular Channel”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 1, March 2017, pp. 50- 68

[8] Yen-Hong A. Chen, Kai-Jan Lin and Yu-Chu M. Li, “Assessment To Effectiveness Of The New Early Streamer Emission Lightning Protection System”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 1, March 2017, pp. 108- 123

[9] Iman Heidarpour Shahrezaei, Morteza Kazerooni and Mohsen Fallah, “A Total Quality Assessment Solution For Synthetic Aperture Radar Nlfm Waveform Generation And Evaluation In A Complex Random Media”, International Journal on Smart Sensing and Intelligent Systems., VOL. 10, NO. 1, March 2017, pp. 174- 198

[10] P. Visconti ,R.Ferri, M.Pucciarelli and E.Venere, “Development And Characterization Of A Solar-Based Energy Harvesting And Power Management System For A Wsn Node Applied To Optimized Goods Transport And Storage”, International Journal on Smart Sensing and Intelligent Systems., VOL. 9, NO. 4, December 2016 , pp. 1637- 1667

[11] YoumeiSong,Jianbo Li, Chenglong Li, Fushu Wang, “Social Popularity Based Routing In Delay Tolerant Networks”, International Journal on Smart Sensing and Intelligent Systems., VOL. 9, NO. 4, December 2016 , pp. 1687- 1709

[12] Seifeddine Ben Warrad and OlfaBoubaker, “Full Order Unknown Inputs Observer For Multiple Time-Delay Systems”, International Journal on Smart Sensing and Intelligent Systems., VOL. 9, NO. 4, December 2016 , pp. 1750- 1775

[13] Rajesh, M., and J. M. Gnanasekar. "Path observation-based physical routing protocol for wireless ad hoc networks." International Journal of Wireless and Mobile Computing 11.3 (2016): 244-257.

[14]. Rajesh, M., and J. M. Gnanasekar. "Congestion control in heterogeneous wireless ad hoc network using FRCC." Australian Journal of Basic and Applied Sciences 9.7 (2015): 698-702.

[15]. Rajesh, M., and J. M. Gnanasekar. "GCCover Heterogeneous Wireless Ad hoc Networks." Journal of Chemical and Pharmaceutical Sciences (2015): 195-200.

[16]. Rajesh, M., and J. M. Gnanasekar. "CONGESTION CONTROL USING AODV PROTOCOL SCHEME FOR WIRELESS AD-HOC NETWORK." Advances in Computer Science and Engineering 16.1/2 (2016): 19.

[17]. Rajesh, M., and J. M. Gnanasekar. "An optimized congestion control and error management system for OCCEM." International Journal of Advanced Research in IT and Engineering 4.4 (2015): 1-10.

[18]. Rajesh, M., and J. M. Gnanasekar. "Constructing Well-Organized Wireless Sensor Networks with Low-Level Identification." World Engineering & Applied Sciences Journal 7.1 (2016).

[19] L. Jamal, M. Shamsujjoha, and H. M. Hasan Babu, “Design of optimal reversible carry look-ahead adder with optimal garbage and quantum cost,” International Journal of Engineering and Technology, vol. 2, pp. 44–50, 2012.

[20] S. N. Mahammad and K. Veezhinathan, “Constructing online testable circuits using reversible logic,” IEEE Transactions on Instrumentation and Measurement, vol. 59, pp. 101–109, 2010.

[21] W. N. N. Hung, X. Song, G. Yang, J. Yang, and M. A. Perkowski, “Optimal synthesis of multiple output boolean functions using a set of quantum gates by symbolic reachability analysis,” IEEE Trans. on CAD of Integrated Circuits and Systems, vol. 25, no. 9, pp. 1652–1663, 2006.

[22] F. Sharmin, M. M. A. Polash, M. Shamsujjoha, L. Jamal, and H. M. Hasan Babu, “Design of a compact reversible random access memory,” in 4th IEEE International Conference on Computer Science and Information Technology, vol. 10, june 2011, pp. 103–107.

[23] Dr. AntoBennet, M, Sankar Babu G, Suresh R, Mohammed Sulaiman S, Sheriff M, Janakiraman G ,Natarajan S, “Design & Testing of Tcam Faults Using TH Algorithm”, Middle-East Journal of Scientific Research 23(08): 1921-1929, August 2015

[24] Dr. AntoBennet, M “Power Optimization Techniques for sequential elements using pulse triggered flipflops”, International Journal of Computer & Modern Technology , Issue 01 ,Volume01 ,pp 29-40, June 2015.

EXTRA FILES

COMMENTS