Xi'an Technological University
Subject: Computer Science , Software Engineering
eISSN: 2470-8038
SEARCH WITHIN CONTENT
Keywords : Thermal cycling, Heat transfer model, Thermal energy utilization, Cyclone separator, CFB boiler
Citation Information : International Journal of Advanced Network, Monitoring and Controls. Volume 2, Issue 4, Pages 202-206, DOI: https://doi.org/10.1109/iccnea.2017.45
License : (CC BY-NC-ND 4.0)
Published Online: 24-April-2018
Energy is the main resource for our country to survive. However, in recent years, the excessive consumption of energy has made the environment worse and worse, and made the development of our country restricted. Technology of circulating fluid-bed boiler is the main way of general clean coal at present, and is a hot topic for each country in the world. However, the experimental process of the technology often spend a great cost, therefore is not suitable in practice. So simulation technology of circulating fluid-bed was used in this paper to solve practical problems. This paper established a circulating fluid-bed (CFB) boiler simulation system based on XinXiang HG-440 CFB, and analyzed final simulation system. Simulation process from thermal efficiency to thermal energy transformation were researched based on rules of thermal cycling and outlet of improving thermal energy utilization.This technology can not only improved the efficiency of energy, but also effectively reduced the energy generated in the process of burning gas pollution. Moreover, it has played an important role in China's energy construction.
S. Kumar, A. K. Mondal, H.Dieringa and K. Kainer,“Analysing hysteresis and residual strains in thermal cycling curves of short fibre reinforced Mg-MMCs,”Composites Science and Technology,vol.64 ,pp.1179-1189,2014.
Wang Jinhui, Duo Jun and Ding Yanlin,“Thermal cycling behavior of Mg-4%Sn-2.5%Pb alloy,” Journal of Residuals Science & Technology, vol.14,pp.420-425,2017.
T.W.Clyne and W.J.Withers, Introduction Metal Matrix Composite. Beijing: Metallurgic Industry Press, 2016.
Bing Liu,Xuemin Yang,Wenli Song and Weigang Lin,“Process simulation development of coal combustion in a circulating fluidized bed combustor based on aspen plus,”Energy & Fuels,vol.25,pp.1721-1730,2015.
J Pan ,G Wu and D Yang,“Thermal-hydraulic calculation and analysis on water wall system of 600MW supercritical CFB boiler,”Applied Thermal Engineering, vol.82,pp.225-236,2015.
S.Y.Chang, SJ. Flemings, M.C Lin,“Thermal expansion behavior of silver matrix composites,”Metallurgical and Materials Transactions A, vol.31,pp.291-298,2014.
P.L.Wu,L.D. Wang,W.D. Fei,“Interfacial reaction in Al matrix composites reinforced by Mg borate whisker,” Materials Science Forum, vol.33,pp.643-648,2016.
Rong Zhou,Thermal Cycling System.Beijing: Electronic Industry Press, 2015.
J Pettersson, C Pettersson and N Folkeson,“The influence of sulfur additions on the corrosive environments in a waste-fired CFB boiler,”Materials Science Forum,vol.55,pp.563-570,2016.
J Pan ,D Yang and G Chen,“Thermal-hydraulic analysis of a 600MW supercritical CFB boiler with low mass flux,”Applied Thermal Engineering, vol.32,pp.41-48,2014.