Search Result

Select Article Type
Abstract Supplements
Blood Group Review
Call to Arms
Hypothesis
In Memoriam
Interview
Introduction
Short Report
abstract
Abstracts
Article
book-review
case-report
case-study
Clinical Practice
Commentary
Conference Presentation
conference-report
congress-report
Correction
Editorial
Editorial Comment
Erratum
Events
Letter
Letter to Editor
mini-review
minireview
News
non-scientific
Obituary
original-paper
Original Research
Pictorial Review
Position Paper
Practice Report
Preface
Preliminary report
Product Review
rapid-communication
Report
research-article
Research Communicate
research-paper
Research Report
Review
review -article
review-article
Review Paper
Sampling Methods
Scientific Commentary
short-communication
short-report
Student Essay
Varia
Welome

Select Journal
International Journal Advanced Network Monitoring Controls
Architecture Civil Engineering Environment

research-article

RHEOLOGY OF MORTAR WITH PORTLAND-LIMESTONE CEMENT CEM II/A,B-LL IN RELATION TO PROPERTIES OF CEMENT

setting time and rheological properties, is ambiguous [4, 7]. The results of the research [8] indicate a reduction of the yield stress and plastic viscosity with the increase in limestone content in cement, while the results of studies [9] indicate the opposite relationships. Authors of works [3, 10] showed a decrease in the yield stress and an increase of plastic viscosity with an increase in the limestone content. The results of tests are usually only related to the chemical and physical properties

Małgorzata GOŁASZEWSKA

Architecture, Civil Engineering, Environment , ISSUE 1, 81–89

Article

Rheological Properties of Pullulan and Aloe Vera Nanofiber Solutions

to the decrease of zeta potential. The yield stress is a key parameter in production, determining the force required to fill a product into its container or to flow. The stress at the viscosity maximum, is a measure for the yield stress. The yield stress is 0.07 pa which it shows that small amount of force is required to flow. Figure 6. (a) Viscosity vs. stress, (b) Viscosity vs. shear rate Cross rheological model shear thinning model gives a good agreement with measured data. γ̇ is the shear

Haifa El-sadi, Shady Sally, Alex Bossart, Dilhan Kalyon

International Journal of Advanced Network, Monitoring and Controls , ISSUE 3, 9–15