Search

  • Select Article Type
  • Abstract Supplements
  • Blood Group Review
  • Call to Arms
  • Hypothesis
  • In Memoriam
  • Interview
  • Introduction
  • Short Report
  • abstract
  • Abstracts
  • Article
  • book-review
  • case-report
  • case-study
  • Clinical Practice
  • Commentary
  • Conference Presentation
  • conference-report
  • congress-report
  • Correction
  • critical-appraisal
  • Editorial
  • Editorial Comment
  • Erratum
  • Events
  • Letter
  • Letter to Editor
  • mini-review
  • minireview
  • News
  • non-scientific
  • Obituary
  • original-paper
  • original-report
  • Original Research
  • Pictorial Review
  • Position Paper
  • Practice Report
  • Preface
  • Preliminary report
  • Product Review
  • rapid-communication
  • Report
  • research-article
  • Research Communicate
  • research-paper
  • Research Report
  • Review
  • review -article
  • review-article
  • review-paper
  • Review Paper
  • Sampling Methods
  • Scientific Commentary
  • short-communication
  • short-report
  • Student Essay
  • Varia
  • Welome
  • Select Journal
  • Transport Problems

 

Research Article | 02-February-2017

RECYCLING AND PROPERTIES OF RECYCLED ALUMINIUM ALLOYS USED IN THE TRANSPORTATION INDUSTRY

Summary. Nowadays, a transportation industry creates a lot of metal scrap because production and use of cars are on the increase worldwide. This is based on the fact that increase in the production of cars increases usage of aluminium alloys in transportationapplications. Therefore, it is necessary to reduce the production of components from primary aluminium alloy and increase their replacement with secondary—recycled—aluminium alloys because the production of recycled aluminium

Lenka KUCHARIKOVÁ, Eva TILLOVÁ, Otakar BOKŮVKA

Transport Problems, Volume 11 , ISSUE 2, 117–122

Research Article | 24-February-2017

MODELLING STUDIES ON THE USE OF ALUMINIUM ALLOYS IN LIGHTWEIGHT LOAD-CARRYING CRANE STRUCTURES

Summary. The article presents the results of numerical analysis whose aim was to compare the basic dynamic and strength parameters of lightweight load-carrying crane structures made of aluminium alloys and steel. The analysis covered the typical construction of workshop cranes with a span of 3 to 5 meters, girders in the form of an I-beam and maximum load capacities amounting to 5 tons. The values of stresses, deflections and natural frequencies were compared and then matched with the masses of

Damian GĄSKA, Tomasz HANISZEWSKI

Transport Problems, Volume 11 , ISSUE 3, 13–20

Article | 31-July-2018

INFLUENCE OF PRIMARY SILICON PRECIPITATES ON ANODIZED ALUMINUM ALLOYS SURFACE LAYER PROPERTIES

In this work, we presented the influence of the anodizing method and parameters, as well as the chemical composition of the used aluminium alloys on the properties and microstructure of the anodic layer produced on aluminium alloys, in particular on the size and morphology of the primary silicon precipitates and the homogeneity of the resulting oxide coating. Aluminium alloys AlSi8 and AlSi12, produced using the die-casting method and subsequently subjected to anodic oxidation were used as test

Krzysztof Labisz, Jarosław Konieczny, Łukasz Wierzbicki, Janusz Ćwiek, Anna Butor

Transport Problems, Volume 13 , ISSUE 2, 111–120

No Record Found..
Page Actions